Which Cisco feature upscales SD and low-bandwidth video participants up to four times, allows them to appear closer to HD in a video call, and is supported on Cisco MCU and Cisco TelePresence Server multiparty solutions?
C. WebEx enabled TelePresence
D. Active Presence
E. Individual Transcoding
Your customer has an EX60 at a home-office that is doing direct H.323 dialing. When they place calls to remote sites, they report that they cannot see video or hear audio from the remote sites.
What is most likely the cause of this issue?
A. NAT mode is not configured on the EX60.
B. The HDMI cable that connects the EX60 to the monitor is not plugged in.
C. A username and password must be configured on the EX60.
D. QoS is not properly configured on the EX60.
Which ad hoc multipoint feature is supported only when properly configured and when the endpoint is registered to the Cisco VCS?
C. WebEx enabled Cisco TelePresence
D. Collaboration Meeting Room
E. Cisco MCU
F. Cisco TelePresence Server
Which tab can be used in order to check the call statistics for the Cisco TelePresence Codec C60?
C. Call Control
E. The GUI cannot be used to view call statistics.
A client requires a versatile desktop video system that supports dual monitors and the multisite option.
Which device should be recommended to the customer?
A. Jabber Video client with PrecisionHD camera
B. Cisco TelePresence EX60 system
C. Cisco TelePresence MX200 system
D. Cisco TelePresence EX90 system
A customer wants to know the options that are available when using all Cisco TelePresence SX Series endpoints in a multisite conference that is hosted locally.
What are three capabilities of the Cisco TelePresence SX20 endpoint during a native multisite call? (Choose three.)
A. ability to change the local layout to prominent mode
B. ability to change the layout of remote participants to prominent mode
C. ability to change the Self-View status of remote participants
D. ability to control the camera of remote participants
E. ability to change the contact status of remote participants
F. ability to change the layout of remote participants to multisite mode
An engineer is deploying a Cisco TelePresence Touch 8 controller for a Cisco TelePresence SX20.
Which two steps are required as part of this process? (Choose two.)
A. Connect the cable from the Touch 8 controller to the Cisco TelePresence SX20.
B. Connect the Touch 8 controller to the power adapter and connect the adapter to the network.
C. Connect the Touch 8 controller to the secondary network adapter on the Cisco TelePresence SX20.
D. Reboot the Cisco TelePresence SX20.
E. Hold the mute button down for 20 seconds while you power on the Touch 8 controller.